Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: two stage op amp design
First of all the process parameters like vt, un, up, lamda..... do matter a lot in your design. I feel that that the parameters you use in your hand calcutions can be obtained through simulations for that particular process and then start using those values in your...
I think your inverter does not cover as much as 100u X 100um area.
Now draw a prboundary with 100u X 100um rectangle. Fill this empty(non inverter)area with the type of layer needed. Better to fill the empty area with small rectangles. If you use a bigger width metal you will have to slot this...
pcell evaluation
Dear all.
I could generate a pcell by loading the pcell skill code...
The problem is that if I quit the icfb once and invoke it again,
the instantiated cell shows pcell evaluation failed. For this the
code has to be loaded again...
Could any one help me in solving this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
