Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have tried to isolate the Digital and Analog ground. the board is having lots of free floating pins which seems to be working as an antenna. If a open end wire is connected to the Clock pin itself causing noise. So i am just stuck in what i am doing. give some suggestion.
Hi,
The scenario is that while I am generating some high frequency clock say 1 Mhz through capture compare pins, some distortion( noises) got added into ADC pins . Because of that the ADC values are not stable. Do you have any suggestion to avoid that. If the clock pin is open the distortion...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.