Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Ahsan,
I was not able to get back to you any earlier as I was out of town on vacation for almost 1 & 1/2 months now. I tried your snubber circuit and a few other versions from the internet after returning back, but it was not all that successful. Hence I think I will stay with the Triac and...
Hi Ahsan, Thanks once again for your replies. I will first try with the 680 Ohms, in order to check for surge current limitations and then try for the snubber. Will post back once have tried both procedures. I only have a small doubt in my mind of weather this same noises and spikes have any...
Hi Ahsan,
Thank you very much for your pictorial reply. I shall give it a try and write back to you.
- - - Updated - - -
Hi Ahsan,
I just tried working with your design. I had connected a bulb to the anti-parallel scr to test the functioning. It started off well, but in between 120 V to 180...
Hi, I am working on a Triac load control using a 4-20mA signal as an input. Have used a TCA785 and the output from Pins 14 & 15 are fed via 2 forward biased diodes and a resistor to MOC 3021. The triac works just fine and I get a decent output regulation on the input 4-20mA variation.
What...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
