Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am using CDMA Wavecom (Q2358C) GPRS Modem with serial port.
I am developing a PC application to access the SIM Toolkit menu
through this modem.
The Sequences I followed [SIM PIN is disabled]
AT+CMEE=1
OK
AT+WIND=15
OK
AT+CPAS
+CPAS: 5
OK
AT+STSF=2,”5FFFFFFF7F”,6,0
OK
AT+STSF=1
OK...
hi everyone,
i have a WAVECOM CDMA module. i am trying to access the Sim Application toolkit.
i did manege to get the main menu using AT+SMGI=0\r command after getting the +STIN = 0 from the module. then i get 4 items in the menu the are given bellow...
+STGI: “e top-up”
+STGI: 1,4,”Prepaid”,0...
ohh! thnx... worked like charm!!
i used
at+cusd=1,"*566#"\r
but, how can i exit from CUSD menu, cant find the exit command. is there any command to end the session?
Hi,
i am working on SIM900b GSM module. in our country we have to check our balance using this command - *566# (grameen phone). it is possible to do for any operator through any mobile. but i cant do it with SIM900b. I tried the following command - ATD*566#
but it shows error!!!
is there are any...
Hi...
i am doing a project with load cell... i tried to amplify my output with LM358 ...but all the time the out put is showing 3.6V. by the way... i using 5V dc supply. first i used a differential Oamp then i amplified it with another Oamp. fact is... all my simulation works well but when i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
