Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am trying to display an image on a monitor/projector using the DVI port of the Xilinx XUPV5LX110T. From the user manual, I saw that DVI port has 4 pins for 4 bits of R G B each. With that it has 6 other pin outs.
I can generate the RGB data. Can some one please help me with the other 6 pins...
I am trying to display an image through VGA port using an FPGA(Virtex 5).
I took a 32x32 image and obtained its bit file (RGB values) using Matlab. I have saved the bits onto an array. If I continuously send 8 bits of R, G and B together in order through the VGA port, will it be decoded as the...
Where can I find it? Any suggestions?
- - - Updated - - -
Its actually an academic project for Engineering. So, synopsis is already submitted. Its difficult to change
Thank you FvM.
The thing is there is only one data, that is the image, in the pen drive. We have chosen so to simplify the task.
I have understood how the signal flow in USB protocol happens. Using the address of the USB port (like the address of the peripheral) cant I command the USB flash...
We are doing a project on reading a simple image from USB flash drive onto an FPGA (The development board being XUPV5-LX110T from Digilent). We have USB IP core from Opencores. How do we use that to read the data and store it onto memory on board?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
