Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: printing in orcad
Its worked for me. My Orcad version is 9.2. Please try again. May be u Miss some thing something. After adding DRL layer to post process list save colors.
Good luck
madhuraka
Thank you for your reply.
But I didn't able to find any way to do this. Merging a PCB isn't fulfill my requirement. Actually I want to assign a routed PCB diagram to a hierarchical block of the schematic. so that repeating is very easy. May be this facility isn't available in Orcad 9.2. However...
My schematic design contains a driver module (for a big LED display). This module repeats more than 64 times. In schematic, instead of drawing the same module again and again I can use hierarchical blocks. But In PCB, with Orcad 9.2 are there any method to repeat this module again and again...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
