Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by m_nader_m

  1. M

    SIM900 and AVR ( level voltage )

    SIM900 and AVR ( voltage level ) hi all, I use the SIM900 based a ATMEGA32 in 5 volt. TX/RX , RI pins are needed to convert the voltage level?
  2. M

    two L298 in parallel?

    Is it possible to use two L298 paralely?
  3. M

    difference between H-bridge based mosfets

    difference between H-bridge based mosfet What is the difference between a H-bridge DC motor driver with N-Channel mosfet and a H-bridge DC motor driver with N-Channel and P-channel mosfet? Which one is better?
  4. M

    N-Channel MOSFET based H-Bridge

    N-Channel MOSFET based H-Bridge
  5. M

    voltmeter read 7.5v WHY?

    Can you offer suggestions circuit?
  6. M

    N-Channel MOSFET based H-Bridge

    what number is the latest version?:cry:
  7. M

    voltmeter read 7.5v WHY?

    MOSFET h-bridge[voltmeter read 7.5v , WHY?] ..........
  8. M

    Where can I purchase Low Cost GPRS Modules

    Please suggest me very low cost GPRS module?Only for connecting to internet not Call or SMS.
  9. M

    Digital Caliper with Ultarsonic

    Where can I find an article about this methode?
  10. M

    Digital Caliper with Ultarsonic

    Note that I'm working with PIC and AVR. Which method of is less complex?(Ultarsonic or Laser[COLOR="Silver"]
  11. M

    Digital Caliper with Ultarsonic

    What should I do?
  12. M

    Digital Caliper with Ultarsonic

    Hi, I want to make a digital caliper with ultrasonic.:grin: accuracy of 0.1 mm and length 30 cm.8-O It can be done by ultrasonic?
See more

Part and Inventory Search

Back
Top