Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
I am using microwave office for simulating filter. I have done with schematic and results are ok. I am trying to use an extraction for converting schematic to EM.
1. How to extract Ground from schematic to Em?
2. How to extract ports from schematic?
I tried converting schematic to em but...
Hi,
I am using Microwave office to design filters. I am designing bandpass filters in the frequency range 160 MHz +/-25 MHz bandwidth and also 160 MHz +/-0.25 MHz. Second frequency range is 1000 MHz +/- 250 MHz and also 1000 MHz +/- 12.5 MHz.
1. Rejection level is 50 dB min away from 3 dB...
need help in combining the results of an antenna simulated and measured.antenna simulated in CST microwave studio and tested in network analyzer for VSWR and radiation patterns in anechoic chambers
hi.....
i am with my project work and would like to design multiband antenna ...i am working with CST microwavestudiov5 ....when optimizing the antenna we need to give multiple frequency ranges..can u tell me how to give multiple ranges for s11 to be better than -10dB..
hello...
i am working in CST..when optimizing an antenna for multiple resonances.. how can we give the multiple frequency ranges in s11 goal? like (1-2,4-4.5,5-6)GHz..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
