Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello to everyone,
I was wondering if there's any way to put a simulated two-port device which is simulated in ADS-Momentum, in the Schematic section.
I simulated a microstrip stub in Momentum ADS. and I want to put this two-port circuit in the Schematic.
How can I do this?
Thanks alot.
array factor microstrip antenna
I think you can define the phase and amplitude of any port separately. Do you mean this? The phase and amplitude of each port is defined separately, therefore you can put the desired phase and scan your pattern.
Hi,
I'm going to design a simple rectangular patch antenna with HFSS,
The patch is feeded via slot coupling.
My parameters are the length And width of the patch And slot. Also The location of the slot under the patch. I think I can also change the two substrates thicknesses.
How should I tune...
Re: HFSS Example
I am using master/slave boundaries to simulate my project.
I use parameters to define the phase difference between the master and slave boundaries.
and I heared somewhere that I can use these parameters to sweep for different angles and plot the dispersion diagram.
BUT I don't...
metamaterial periodical
master/slave is very simple.
just select two walls and then assign the master/slave boundaries to each one (separately, one by one)
.
I have a question,
how to plot dispersion diagram in hfss?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
