Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Manju.
Thanks for your reply, I could simulate the switch but the other manner, I obtained the model to on Switch and off switch with lumped elements and I used the aplac simulator, I had a very good response. I hope to have your help to other questions.
LuisFe.
Hi everyone.
I need to simulate a SCswitch in mwo, I need to change the state since off to on and simulate what happen in transient analysis when the state change, I attached the pdf file that I'm using but the simulation show me some errors " identifier expected line number: 24 # ScSwitch...
Hi Manju...
Thank you for your help, I changed the extension and imported it, but MWO show me some errors, I attached here the errors and the *.lib so you can give me a hand again, in this moment I have the subcircuirt but I'm not sure if that block is working.
Luisfe..
Hi....
I need to use the file with extension *.lib in MWO to generate a schematic and make some simulations, I followed these steps:
Circuit Schematics->Import Netlist to load the file, but when I search in subcircuits and try to put it in there, I get the message "bcr400 has no ports"...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
