Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Ok, I will try!
I want to do it because I am measuring a farfield at a certain distance from a small loop antenna which is not self-resonant with a probe and if the antenna is not matched, what I measure is a very small value.
just I am here, I have another question for you, since you look...
Hello mates,
I have a very tricky question for you today:
I need to simulate an antenna (loop) inside a pipe full of water. Obviously the antenna has been protected by a proper radome.
I need to know the farfield of the overall structure, but a problem occured.
Suppose that the plane of the...
Ciao Enrico!
Thanks for the answer, but as I have written in the first post, if you put a lumped element in the same points as the port, then CST give me an error: "the lumped element has the same mesh location as the port"
regards,
Luca
Hello everybody,
My problem is very simple, I just want to put a capacitance as lumped adaptive element IN PARALLEL with respect to the generator (discrete port). I know that exists the macro->construct->discrete port with lumped element, but this macro allows only to put a SERIES element with...
Hi Praful,
Thanks for your reply. what I wanted to do was to fill up a radome which is very similar to an 'egg'. i tried to extrude but this option allows you only to extrude planar surface not elliptical. What I have done is as follow:
I have defined a sphere (made up of the material I wanted...
Hello everybody,
Does Anyone know how to fill up a generic volume with a certain material using CST Microwave Studio Software?
Thank you...it's time that I am trying without success....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.