Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone, I have written my coding to count the revolution per minute of a motor, does anyone know how to pass the counted value to lcd? how to write it ? my coding is below, i really need u guys help, thanks a lot, if u guys feel it's too long, u can straight jump to the void value() part...
Hai, I'm a fresh starter for the project. I've done some research about the calculation for rpm. A counter and a timer are used to measure the rpm but i have no idea where to begin. I'm writing this in C language, can anyone give me some guidances?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
