Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
When I run PSS simulation on a divider by 2 (just a DFF with negative feedback), but it always can not be convergent even if I set large tstab and steadyratio. Can anyone tell me what I should do?
Re: TFT Source Driver
The main power supply is 2.5~3.6V. But there is LDO regulator (1.8V) inside the chip. It will provide 1.8V power for internal logic/memory, etc.
use resistor esd
Diffusion resistor can spread heat very quickly while poly resistor can not since oxide is arround poly. Poly resistor is more easy to be burnt than diffusion resistor at ESD zapping.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
