Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i figured out the problem , and fixed it
my next problem is i want to do serial communication with virtual terminal in proteus
Can someone help me transmit the Result into VT ?!
Onebit Add/Sub using 8051-HELP
Hello Friends:
i'm trying to do one bit simple calc(using 8051 MCU) , which can take two numbers and operator from the Keyboard (save the numbers in RAM)
then do the math
the problem i'm facing , i end up having wrong numbers when reading from RAM .
here's...
@Frag
Yes Sir this was helpful i could show up the two values
Now i have the C code for showing the values , and the main c (with the Nokia LCD)
we need to combine both to get the ability to show the real values
C0-C7 is connected from the Resistors to the port C on the pic
and then from Resistors to photo diode of the sensor
Pin 8 , 9 it's the bypass Capacitor for LCD,PIC, EPROM
i meant the picture above , anyway
here's the Design by narccizzo
https://www.edaboard.com/threads/95352/#post962154
you can see the electrical schematic and how to connect to the LED,photodiode
@Jongs :
@leonel : regarding the sensor , you can use two LED (infra & RED ) with the photodiode directly without the need of 555 (if you are using narracoz design )
(look on the photo provided by JONGS how he attach them directly to desired points)
other solution , which i'm doing , is to use...
Thanks Fellos
i think the best way is to change the display
i'm trying to do that , using 16x2 LCD display and modifying the code to make it working
the problem i'm facing when using a simple code to view two words (SPO2=,PPM=) (and some constant values ) in proteus it doesnt really show the...
@Fragrance : thanks for answering my question
I'm trying to do the same circuit JONGS did , i found the same problem in the display pin configuration
@Jongs , have you test the signals in the Testing points ?! if they were right as the ones given in the schematic i think you are only having...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.