Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
yes that was a silly question
Added after 36 minutes:
i could not get 100db gain(like in the paper) for moderate inversion region
with 4mv offset voltage the gain is 80db
and also for strong inversion:with 200uv offset voltage,gain is 35dB
any way to increase the gain?
Congratulations Mr Raper
however this gift is very little Compared with your Patience in answering the questions and helping other
i hope the best wishes for you
Good luck
in the shematic without a current controlled voltage source if i want to input the direct command in the netlist for plotting gm what is the plot command?
Added after 10 minutes:
it means that i want to plot gm with the other gragphs Simultaneously when i run the shematic
it gives the same error
i deleted the other .keep in the netlist and added .keep /SUBS
is it true that for plotting gm i should devide the Drain current of M4 to gate voltage of M9(refer to the picture) maye be the error is here!
it says
Error : Cannot find vector of name 'Q4#D'
the reason is that in the netlist it does not save the point that i need for plot the gm
how can i say SIMetrix to save the volatage and current of Desired point in the netlist.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
