Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
it came from an old nmos/cmos layout file missing label. I just did a reverse to have it in schematic maybe somebody know if this is generic schematic? or not?
Hi everyone.
I am trying to create a project using a photodiode and an ADC. I would like to characterized the ADC Gain by using the different Light Intensity fetch by the Photodiode. Do you have ideas on how to start this? Thanks for your help.
Hello is available test development kit onlinethat i can buy? Where i can use to teach my students on test devlopment from scratch? From continuity adc dac leakage and the likes?
Hello I have been ask a product engineering question and I want to check my answer.
I was given a series of good device yield
Good yield
90.43%
90.86%
94.79%
90.03%
96.00%
96.19%
95.02%
95.77%
94.80%
92.32%
95.41%
and Reject (example failing Continuity)
0.1%
0.1%
0.0%
0.1%
0.4%
0.3%
0.5%
0.7%...
Hello I have a problem of noise of about 4251 nV for the frequency 3-400Hz at Hot. Can anyone advise me on what should i look into about the characteristic of noise at lower freq with respect to temp. ? Thanks in advance.
Re: PLS HELP THIS NEWBIE.... How to design a pcb layout circuit from a old pcb board?
Your the only one who can check it since you have it ( I can barely see it). Check the Partnumber of bigger IC search it in the internet. R-resistor, C capacitor D-diode check connections. most important is...
Re: PLS HELP THIS NEWBIE.... How to design a pcb layout circuit from a old pcb board?
Its possible but it will take a hell a lot of effort: you need to know if the PCB used is multilayer , the components and connections.... goodluck!
---------- Post added at 08:56 ---------- Previous post was...
Hello, in test we encountered a temperature related Trimming issue. Perfectly trimmed at ambient while having a temp drift in high temp. Do you know where to attack this kind of scenario?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.