Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In 8-bit mode, I knew that the sequence to write data to CS8900A in I/O Space Mode (default I/0 Base Address) is: write 1st byte to 300h, 2nd byte to 301h, 3rd byte to 300h, 4th byte to 301h, and so on. This operation sequence is applied to read operation too. What if 16-bit mode? is the...
Thank u, Dainis. But the 32bit CPUs seem a bit too much powerful, advenced and complicated for me. I need only the 10/100M Ethernet function. The AX88796 states that it supports MCS-51 series, 80186 series, MC68K series CPU and ISA bus. Meanwhile, the LAN91C111 supports Multiple Embedded...
asix ax88796 usd
If I were to unsolder any network controller chip from an unused Network Interface Card, will it work? The network chip will communicate to the Ethernet by being connected to one of the ports of the switch. The PIC will give instruction to the network chip to send & receive...
ethernet data tester
Firstly, thank u Dainis, for ur opinion. Oh, actually I'm talking bout Fast Ethernet too. I'm still new to networking. The "magnetics" u mentioned, do u mean something like 100Base-T Isolation Transformer module chip that would be placed between the network controller chip...
embedded processor host interfaces
Hi, good greetings to everyone. I was required to design an Thernet LAN Data Transmission Tester (Ethernet Monitoring System) to test the quality of digital signal transmission and the condition of communication channels of a simple Ethernet LAN using a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
