Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
SuperTubeDude,
You can use the GPIB controller to set the serial number, send the command:
$$SY_NO 01234
You don't need to worry about calibration, the variables are saved in a real eeprom that is not on the cpu board, and the scope recals itself all the time.
The 8.2.2 firmware needs the...
Hey guys,
I'm working on some prototype PCB that I will manufacture in house. This is my first project with Cadence, and I haven't been fortunate enough to have the training yet.
Using FPM to create footprints is really nice, but it would suit hand drilling better if the pads were hollow...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
