Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you mtwieg
Any document / website with guidelines/rules of thumb for transformer selection?
I will try too, but advice of an experienced person will save my time...
Hi,
I need to design a 24V dc (input supply tolerance 19.2V to 32V dc) to 5V, 3A dc converter with 1.5KV isolation between the input and the output.
I want the dc-dc converter to have a high efficiency (90+ if possible) and low ripple (<200mVp-p) at the output
I don't want any software...
@nksunmoon
What alexan_e said is right...
Please furnish the details clearly...
Amplifier generally refers to voltage amplifier...Is that what you want?
Please give the voltage range of input and also the load the amplifier must drive
hiii
we used the PA86EU opamp manufactured by Cirrus Logic / APEX
We have given input 2.5V and amplified it by 40 times (to 100V)
It works very fine and the gain is also resistor dependend
We can obtain output upto 250V (sigle supply) or +125V, -125V dual supply
We can control the Slew rate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
