Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have designed the waveform clipper Circuit using diode, please find the attachment for my design,
In this my input at P2V-IN is 0-5V square wave and am expecting the output as +6V to -8V square wave output but am getting output as +10.2V to -10.2V could any one please tell me what will...
Hi All,
I want to design a transformer for Xneon Flash Lamp Power supply, can any one tell me what is the Clearance and Creepage distance required between primary and secondary winding also temperature class for primary, seondary winding and insulation material as per the UL or any other...
Hi All,
Am using Epson S1D13742 display driver to drive Sharp LQ104V1DG62 LCD, after i configured everything the display working partially, means from the beginning and middle its not displaying anything by this time the RGB output its self is not there but all other signals like HSYNC, VSYNC...
Arunava7,
Thanks for your replay,
chapter 4 and 5 talks only about coupling and power supply circuit design but i want to know about TX amplification and RX front and
Hi All,
am designing Power line communication light control device using PL3170 please any one tell me how to interface this to AC(230V) supply,
Thanks in Advance,
Kingssk
HI,
in my new project am using NHD-7.0-800480WF-CTXI#-T LCD with 18 bit RGB interface, this display don't have VSYNC and HYSNC pin,
please let me know how the display will work without HSYNC and VSYNC, is there any way to make it work, display controller which i am using to convert 8 bit...
Output of transformer is -1260V, by using voltage divider 10M and 11K||100K input to OPA735 Opamp inverting input is -1.26V this will inverted into positive 1.26V and given to the feedback input of LM5001 based on this feed back voltage it will control the transformer output voltage.
in my case...
i designed single supply inverting amplifier using OPA735, when the opamp output is connected to load , the output voltage getting drops upto 1V,
please anyone explain me why it is happening
Please check the attachment for my schematic
Thanks in Advance
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.