Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey friends .. i know it silly question..! but can you help me to get MULTIPLE RETURN LOSS PLOT ON SAME GRAPH SHEET
Example be like .. changing parameters and plotting their return loss on same graph sheet!
Thank you!
I have made a Slot patch antenna with square slot.. with CPW fed, the ground plane are on either sides of the signal/patch..! i have some quires:
- how to differ between a signal/patch and ground since both are assigned boundary signal/patch=perfectE , Ground=finiteconductivity, The differ i am...
Would please anybody complete this patch antenna that i have attached...!! I Am confused on how to excite a Coplanar waveguide fed.. and which solution setup would be applied Driven model or driven terminal, I read the Help section ... but technical terms is hard to understand. Moreover, I am...
Thanks.. yeah you are right. I am using HFSS12 v.1
I used lumped port just because it was used in some research paper.. so i used it.. I am new to Coplanar waveguides and it's feeding technique.. and actually I don't know how to excite a CPW.
I look forward in conditions to accommodate the...
Please help me to find a excitation to Cpw-fed.
I tried but their is an problem like..
"[info] Fast sweep setup, process hf3d: '1' conductors touch lumped port '1', typically a lumped port contains 2 conductors. Please verify conducting boundaries and objects are correctly assigned and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
