Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
Actually i am working on the ADuCM360 of Analog Devices, i have to develop the RS485 driver based on the Pin P0.5 as Rx, the Pin P0.4 as the Tx and the Pin P1.0 as Sel (select).
Can anyone provide me some tutorials that shows how to develop an RS485 driver (embedded C) in a such case...
Thanks for your response,
I know that in the physical layer, the UART frame format is set to 10 bits 8 bits of data with start bit and stop bit. While i have to define an UART frame in a higher layer for example i have to define a configuration frame that will be as follow...
Hello,
I am working on the design of the UART protocol using the Cortex M3. In that context i will use three type of frame, a configuration frame, a data frame and an acknowledgment frame.
So i was wondering if you can help me to get some information about an UART frame (header, tail....)...
hello everyone ;
i am working in a project to simulate the method of energy detection for siso system.so i am looking for a matlab code to simulate this spectrum sensing technique and to get some knowledge to begin and deal with the project .
please i need your help ,my email is...
hello ,
i am a student in the high school of telecommunication of tunis and we are supposed to abord a the csd decimation as a project so the first task we are needed to do is to design a HB filter with fdatool .
the standard that we are working for is UMTS and the frequency is 200mhz ,so after...
hello ,
i am a student in the high school of telecommunication of tunis and we are supposed to abord a the csd decimation as a project so the first task we are needed to do is to design a HB filter with fdatool .
the standard that we are working for is UMTS and the frequency is 200mhz ,so after...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
