Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Only in liquid helium with superconductive cavity. And -190 is IMHO impossible, only 180-185 because active device noise is degrade cavity performance. Look at the pearametric pumping oscillator with quantum amplifier.
oscilloscope circuits
Tektronix use analog time interpolator like see attach. Also refer to us patents
US3790890
US4301360
US4728813
US5790480
US6194925
Chameleon is self-programmed device. Your may download svf files for various RAVEN configuration from AMONTEC site
https://www.amontec.com/download.shtml
usb blaster driver
VID/PID
09FB/6001 - USB Blaster
09FB/6002 - Cubic Cyclonium
09FB/6003 - Altera NIOS II Eval Board
Protocol looks a little similar to Altera BitBlaster protocol, differences full 8 bits are used.
0000 0000 NOP? *64 used to ensure the bit output buffer is empty
0001 xxxx ...
sti5518s loader
sti5518 not usually copy code from flash to RAM. Only flash subroutines copied to ram at sat tuners with only one flash chip installed- when flashing process in progress ( like channel list update or firmware update) flash is not accesible, then flasher code execute from RAM.
At...
led time response
Photodiode of cource.
Phototransistor is much slower than photodiode, its work in kHz range. And phototransistor detectivity (A/W) is more nonlinear then photodiode. Usually, phototransistors used for detect on/off switching light and direct drive logic IC input.
rise time led
Your need fast Si photodiode with 50 ohms oscilloscope load. If expected rise and fall time is in nanosecond range PiN photodiode is useful. If rise and fall time is in picosecond range ( laser sources) your need avalanche photodiode.
Look at Hamamatsu photodiode catalog and...
jtag simples
One of possible way to connect your debug hardware to ST toolset is substitute
tcpos.dll (B300 link box driver) by new version. Sources and header for tcpos.dll compile is found at https://www.acfr.usyd.edu.au/technology/transputer/toolsetSupport.html
at the "NT toolset source"...
usb blaster circuit
For correct reengeneering VHDL code for any CPLD version (Xilinx or Altera) some
tests need.
Is one transaction wrom FTDI to CPLD (one #RD pulse) produse only one transition on TCK line? Or one pulse on TCK? Or many pulses ( data from usb are serialized in CPLD)?
Can anybody...
bistable relay schematic pulse
At the single coil latch relay coil is usually deenergized. Only for switching some short pulse is applied to coil. One polarity pulse is switch relay to On state and reverse polarity pulse is switch to Off state. Good appnote from Maxim for driving this relays...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.