Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: SEGV signal Silvaco
I had this error while simulation.
The solution of this problem is to check the region section and have to make sure that you specify the max and min of all the layers.
E.g.
region num=3 y.min=0.120 y.max=0.140 oxide
Ans also remember to include all the regions...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
