Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All,
I think I have figured out the solution. Posting it here.
As one of the users suggested, the meshing should be made curvilinear. However, don't forget to add checkmark once the property of 'ApplyCurvilinear; appears on the left pane.
This alone won't work, add surface approximation...
Hi all,
I am simulating a leaky wave antenna in a conformal environment in HFSS (see Fig.1). The model simulates without any error. But when I plot the mesh view (see Fig. 2). The mesh is deformed and it does not resemble the curved structure I am simulating.
I have reduced the rendering...
Hello all,
Sorry to reply a bit late. But here is my long due resolution .
The key here lies in visualizing each of the mode at different k0*p (or angles). If you look at my graphs that I have attached in my replies, there actually exists the dispersion behaviour of the unit cell that I want...
Thank you for your time.
The CST results, I don't think they are correct, because they are the same for waveguide (without pattern) and and Leaky waveguide (with pattern).
I have used the impedance boundary condition and not PML, and I feel like yes there is a mode present which I need at...
Hey thank you so much for the replies and taking the time for providing help :). But I don't seem to be getting the results. I simulated the model you sent and tried the parametric analysis; I got this (screenshot attached). I think HFSS is finding modes which actually do not exist (or cancel...
Hello,
Thank you for the reply and pointing out the PMC boundary. I tried simulating with the following boundary conditions (in the screenshot), in both CST and HFSS in eigenmode and got similar results but not of the paper. I simulated until the 20th mode, screenshot attached but none of them...
Hi,
I am trying to perform eigenmode simulation to obtain dispersion diagram for a paper "https://ieeexplore.ieee.org/stamp/stamp.jsp?tp=&arnumber=9055410" Figure 3 (b), but I am not getting the desired result. I have tried performing the simulations in both HFSS and CST and the summary ppt (of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
