Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI Everyone,
I am looking for a header connector (say 1X2) sach that by default it should be short and at the time of measurement, all current should flow through ammeter. I dont want to use jumpers by default.
Kindly help if these type of header connectors are available having some...
Thanks for your attention and answering the issue.
I am explaining the situation i have seen. I have 5 v supply through which i am feeding input to two different LDOs connected parallel to it.at the output of capacitor, I see 47 uF shunt cap ( case C, 10 V) and after parallel connections to...
LTCC Technology Fabrication is quiet Difficult
I am thinking in involving step Discontinuity in top layer and Defected ground together.
Also, as thinkedd of substrate is 8 mils... might be it helps in miniturization
what you suggests guyz???
thanks fr your response
I am planning to use Defected ground to create miniturization and addtional LC generation with ground discontinuity.. Lumped Element is not acceptable. This is the big issue
Regards
Hi Every one
I am Struggling for Development of 4mm* 4mm Size Low pass Filter having passband at 2.4G but strong stopband at 4.8 GHz and 7.2 GHz using Microstrip with Substrate thickness 8 mils.
I am using HFSS in this Regard
Any Suggestions
Regards
IT mean that how much the power in first mode at port 1 when second mode is induced at port one,
Now what is mode 1 and mode 2
check the waveport excitation and see the modes( you can see all modes that much u have inserted)
For just memoriseinf .. LIAO is good one..( no concept building)
For detailed start - FOundation of microwave engineering by RE Collin
And Advance Electromagnetics by Balanis is best one
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
