Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi
i faced a big problem,
i use 4 RF moduls, & 16F877A pic.
here i want to transmit the data from RF(XBee) to RF.
one RF recive the data packets from ather 3 RF moduls at the same time period with out packet lost & overfloo.
here i use C (microC) language.
plz help how to sent the data packets...
tmr1h
The problem is this:
The time is calculated using timer 1 in PIC16F877A microcontroller. The measured value is stored in the TMR1H & TMR1L registers. I have this value now in an int variable. I need to convert this value to hours since we need to do our calculation in km/h.
It involves...
arabic font on lcd with microc
i need the code for,
a (int value / flot value)
or
any format value(number) devided by any value and display in lcd
thanks a lot
S.kaArthIc
hi friends,
i need the microC code for following matter,
i use two sensors, the pic16F877A get the signal from 1st sensor the timer ON,
when the signal get from 2nd sensor timer OFF, then calculate the between time on & off.
plz help as soon as posible
thanks a lot.....
S.kaArthIc
hi friends
i want a help from u.....
i want a "C" code for get the signal from RF module & display the LCD display board via PIC 16F877A
here i used portD for LCD
& pin RA2 for RF module.
plz help.
thanks for ur help
hi
i use pic 16f877a
i want to sent signal to ultra sound sensor through PORTB pin0 and get the signal from sensor through pin5,
here i want to calculate the time also (between sending & receiving time)
plz sent the c code for this problem
plz help me
i want
"c code for character display in 2X16 lcd using "16F877A" "
use portD pins for connecting 2X16 lcd display bord.
plz help me
thanks a lot 4 ur help
simplelcd
plz, can anyone pls post a simple LCD code for me?
I just need to know how to show a word in a 2x16 LCD.
I'm using Microchip PIC16F877A at the same time i want get signal via RF modul
Preferably PIC C language!
I try the routine provided by them but still doesnt work.
Thanks...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
