Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I used a gate driver from Fairchild (FAN73832) and connected it the way the datasheet shows (image 1),
and I expected that both outputs high side and low side to range from 0V to 15V.
But when I connected the chip and measured the output, the high side output ges from -5V to 10V.
I...
Hi
I was reading the datasheet for this part (FAN73832) and I found in the logic characteristics section something about 100K ohm input pull down resistor.
does that mean I have to connect a 100k Ohm resistor between the input pin and the ground pin?
my input is 5V TTL PWM signal supplied by a...
Hi,
I am building a half H bridge consisting of two IGBTs and two gate drivers.
both IGBTs are driven from one PWM source, one IGBT conducts when the PWM is high while the other is off, then the second IGBT conducts when the PWM is low while the first is off.
What can I do to introduce dead...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
