Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys,
Thanks for your reply. How do I improve the power transfer to the from the transmitting to the receiving. ie the circuit receiving circuit w/o the full bridge rectifier.
Brain, thanks for your reply. Using 1n4005 I'm still able to get decent 10v O/P from the rectification. What I'm concern is that after putting an load I'm getting 0v from from it. Could it be low power that antenna is receiving?
Hi guys,
I'm currently working on a wireless power transfer project. I've problem with the receiving end of the power transfer.
I'm using 1N4005 rectifier diode for the full bridge rectifier with smoothing capacitor(1uF) the o/p is about 10v dc . However, after putting an actual load ie blub...
I'm planning to use ZXGD3001E6 as a gate driver. However, I do not understand how to use it as a amplifier to drive the gate.
by generating a square wave using logic gate I suppose that the circuit u mean by using the circuit below?
Hi guys,
I'm trying to build a mosfet gate driver circuit at 13.56MHz using crystal oscillator to generate a square wave to wave with 5v peak. Is there any schematic i could look at for this project
Any help will be appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
