Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I am going to convert a parallel data to serial data (6 bits), please advise a suitable MCU (vendor & part number) that can perform this conversion.
Thanks.
1. Mode conversion: IS it stating that changing from TEM to TE or TM ??
2. TEM is a very good mode for EM energy transmission? then how about TE or TM mode ?
3. Why after a certain high frequency (cutoff freq), the TEM will change into TE or TM mode?
4. For a transmission line, the denser...
connector simulation model
For a single connector simulation using HFSS, please direct me if you have any comments on it:
Please kindly download my file and check any part of it has error!
1. For a practical case, do I need to setup a definite thickness of the outer shield cylinder...
V supply in GaAs
Why the voltage supply used in GaAs device is higher than CMOS device?
Is it related to the bandgap energy or any other parameters?
Please advise me some textbooks/app notse on this issue..
Dear all,
A standard *.s28p failed to translate into SPICE model using ADS2003C -SPICE model generator. However, a standard *.snp, where n<10, can be translate correctly into SPICE model using ADS2003C -SPICE model generator.
I checked the @DS manual, it stated that the SPICE model generator...
spice model generator ads
Dear all,
A standard *.s28p failed to translate into SPICE model using ADS2003C -SPICE model generator. However, a standard *.snp, where n<10, can be translate correctly into SPICE model using ADS2003C -SPICE model generator.
I checked the ADS manual, it stated that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.