Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I use PSIMCAD as power electronic simulator and i think that it is really better than PSPICE for this purpose. You can dowload a free version from:
www.powersimtech.com
Antonio.
I have to communicate two analog Devices DSP, everything works fine when I send messages only from master to slave. But when I set the bit EMISO (bit 5 of SPICTL) for sends data from slave to master the system stop work and I receive only wrong data in both sides. Please if you have some advice...
Dear friends
I must use this DSP, and make a program until to the end of this year, but i don't know anything about this assembly and i'm think in use C to program them. But i have a question: How good is this C compiler? Is it eficient? Could i have problems with the execution time? What is...
Thanks guys for the answers.
I have just one more doubt, is it work fine when you are using five or six transistor conect in paralel?
Thanks again
Jundiaí
shunt resistor pic
Hi friends
I'm using a PIC16F873 to generate a PWM that drive a NMOS transistor that drive a motor DC. But now i need read the current that flow throw the motor and i don't want to use a shunt resistor. Coul you tell another cheap sugestion?
Thanks guys
Jundiaí
How can i do it?
I have a PIC comunicating with the PC by the Hyper Terminal, but now i need create a interface to the users and i don't know how. I know how to program a few in delphi, c++ and labview, but i have never programed a serial interface. Which language i must utilize? How can i do...
avr detection of cross zero
Please i must know how can i do to find the cross over of the power line using pic, what hardware i should use? And how can i make the software?
Thanks a lot and sorry about the english
Jundiaí
There is a free version of Code warrior compiler from metrowerks, you just need register your copy and make code <4Kb in C and the assembly is unlimited; :)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.