Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
from the figure，we see that the current units is mA。
But when I export the .inp file, I see uMKS in the .inp file.
Like this:
But I know the current unit of the uMKS is pA. Like this:
So, I am not sure what the final current unit is !
TLP Simulation in ESD：How to generate the pulses，what do the pulses look like？
A relay is used in the simulation model，should it be working all the time？ Continuely opening and closing？
Input one pulse to the D.U.T，so one I-V point was got，right？
So，many pulses to the D.U.T, the I-V curve could be got，right？
What are the characteristics of the pulses？ Amplitude？Rise time？
Thans！
Hi Erikl，I am trying to simulate TLP（transmission line pulse） model，could you give me some advices？
How to set the transmission line parameter，like delay time、electric length？
How to define the charging time and discharging time？
Re: does anybody give me H-SPICE code in HBM model for ESD device
Thank you very much！
I see，you set 1.001ms to achieve enough time for charging and discharging.
Could you tell me the name of the software you used？
Can VCR replace the switch that in your schematic？in spectreRF
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
