Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Receiver put to binary mode, but new issues arise. Data is now in two stop bit mode even that request by NMEA message $PSRF100,0,38400,8,1,0*3C is for one. This prevents my MCU to alter data since it only supports 1 stop bit data. Another issues is that in binary mode data stream is not halted...
Hi,
In my project, only GGA and VTG messages are needed, so I configured the module by NMEA protocol messages to disable all other messages. Everything works fine until after 135 seconds module sends a message: $PSRF150,0*3E which is "not OkToSend" -message. The serial port is completely halted...
Thanks for the reply, LTC3862 isn't a charger but a boost converter without CV/CC. Perhaps you could build one with additional controller but I'm more looking for stand alone unit here for 12S Li-Ion.
Thanks for the output but LTC3862 is just a boost switcher regulator. Perhaps you could convert it to CV/CC charger with an external controller but I'm now looking for a stand alone unit. There isn't too many available as far as I have found, all of them end at 36V lacking my requirements of...
Hi,
I'm on my way of choosing the charger for 48V Li-Ion pack. First, do you know any alternative to LTC4020 to charge the 48V pack with 2Amps? So far I think LTC4020 is the most suitable, BUT... it is a buck boost charger and at the end I only need Boost section of the charger. So is there app...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
