Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
what type load you are planning to use with traic? if it inductive you need to consider surge current also. 12A min continuous current traic can use for 8A resistive load.
HI
J1,J2 and J3 are analog in/out put, V1 and V2 and selection controller pin, Isolation means there is no connection and Insersion loss means there is connection with some loss in output. V1 and V2 are logic voltage(2.7V-5V)
Thanks,
HI,
I am not sure about part number. I think this is 8/16bit parallel interface lcd. I will try to find out the driver details for you If you share pixels(VxH) and size of lcd, or the product page address if you brought this online.
thanks.
Hi
Metal detector basically using a tuned LC circuit (parallel Resonance). Inductor will used as detector and this inductor have parallel connection with a capacitor. This tuned circuit will start to oscillate at particular frequency.
f = 1/(2*pi*sqrt(L*C)
if any metal object near to...
Hi,
First you start with some generic device class example code. Later please move on to your specific device class.
Below link may be useful for you.
https://sites.google.com/site/coolembeddedlaboratory/home/pic18f4550/tutorial-list/usb-commnication-using-ccs-pic-c...
Hi,
if you get lcd based on mobile model number, get that one and search on google for driver chip details.
or search in google for commonly available mobile lcd driver details and get that particular lcd. eg Nokia 5110 LCD
Hi,
sorry, I am little confused with your requirement.Which one is highest priority, AN3 or AN4?. Are you using only one device at a time(tempsensor or POT)?. do you want to identify the channel only if the tempsensor is present? if not go to below section
Anyway if both device is connected...
Hi,
Its there in datasheet.
It's a SPI communication so no need to set any device address in communication.
Use CE# pin for chip selection and use above mentioned code for data transfer and erase.
Thanks,
Jolly Jacob
Hi,
You will get lot of TFT LCD in ebay but not sure about ILI9525 Driver. search with 1.8 inch or 2.2 inch lcd text. ILI9341/ST7735 is very common lcd driver but no idea about mobile phone application.
Thanks,
Jolly Jacob
Hi rana_tdm,
I am attaching some documents link which you are looking for.
https://www.ti.com/lit/df/tidr753/tidr753.pdf
**broken link removed**
Please redesign as per your requirement.
Thanks,
Jolly Jacob
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
