Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have replaced PSU. as burn marks showed damage, red light was flashing then staying on stand bye.
After replacing the PSU. I then was advised to replace the Main board, After replacing the main Board still nothing, except the red light blinks continuously now, As I said I am a complete novice...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.