Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
lpc2103 examples
Dear All,
Currently I am using 8051 and know litle bit about AVR. ARM is completely new world for me. I have D/L the datasheet for LPC2103 from philips website.
I found out the datasheet is not in deep & detailed explain about the chips. No data about the registers, the...
make your own ac servo drive
Hi,
Just an wild idea. Can we make it with DSPIC, IRMCK201, ATMEGA?
What I mean is a fully Vector-Control AC Servo.
Just curious. Anyone has been in such project? Please share, we want to hear from you.:D
Thx's
TR2000
Re: Is it possible to clone of the XDS510PP (TI DSP emulator
Hi Boy123,
The link is in chinese :? :. Can you please give any hints in this forum?
Thanks
TR2000
Re: Sound Cancellation
Dear All,
I know may be I am asking to much to cacel the sound in whole room, but I have heard that this technology has been used on :
1. Air plant, to minimized the noisy jet engine sound.
2. Some high class car to minimize the sound/noise frm the engine.
Ok, I will...
Re: Sound Cancellation
Hello hr_razaee,
Have you seen somebody has implement it with the real DSP circuit?
I just wander where to put the transducers (microphone and laudspeaker) in the room. I think we also have to give the close loop control for this. Is there any clue?
Rgds,
TR2000
Dear All,
I just wander that we can make sound cancellation. What I means is to cancel the sound or/and noise from outside the room (target room), so that the room is quite enough. I need to make the quite room with "active" way, not with the "passive" way, such as using sound damper in my...
At last, there is some one response the post.
Yes, you are right. I want to apply RTAI on linux kernel that I get from www.kernel.org
My aim is to install the EMC that I get from the sourgeforge site. I have follow the step on installing on RH8.0 in the hand book of EMC, but the result I can...
I have install RH-8 on my PII-400 with 128MB RAM.
I want to upgrade the kernel to 2.4.20 with RTAI 2.4.11 patches.
I do this with the referece of EMC integrator handbook (on Sourceforge) with every step.
After that I try to test the "realtime" with the example in the RTAI before I install the...
Re: Servo motor control
IR have the special IC to do the AC servo control job. They also have a good IGBT/MOSFET driver, and the IGBT themself.
Try their website www.irf.com
Good luck
TR2000:D
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
