Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Copper Pours
Design is a mixed signal 4 layer board; rf single ended< 500Mhz, rf diff pairs <900Mhz and a dsp. Is there any value in adding a copper pour around the rf traces with vias every 1/20th wl?
Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.