Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello Experts,
Please find the attached file and give some idea about this component.
I want to create foot print for this component. Is it a SMD or Through hole component? Please tell me how to mount this component?
Thanks in Advance!!!
Kind Regards,
Jayasuryan
Re: Layer Stackup Rule
You can define Layer Stackup-as per your requirement by considering following....
1. Signal Integrity
2. EMI Effects
3. Decoupling
Keep in mind the above constraints and define Layer Stackup. If you keep GND-VCC planes close to each other in multi-layer PCBs that...
Re: A Basic question
If the grounds are connected with a high-impedance path, then there is a voltage drop between the ground pins.This causes disruptions to all of the devices referenced to this ground and can degrade input noise margins.
Hello All,
1. What is the Use of split planes in PCB?
2. In what basis they will define?
3. Any rules for defining split planes in PCB?
4. Is there any problem with defining split plane for same net in different layers?
Thanks in advance.................
Re: help need in pads
Supposes if u are going to place stitching Vias from one pad to some plane....U need more Vias from one PAD to bond the connection....at that time u need to take more track from one pad.Then u can use Single Net Clarence DRC,If U want
Re: help need in pads
If u want u can use copper line(path) to connect two points.But it will show clearence error in DRC check...but doesn't matter.............
Hello.......
1.Install pdf writer Software
follow the link and download anyone
http://www.pdf995.com/
http://www.cutepdf.com/Products/CutePDF/writer.asp
**broken link removed**
2.Finish ur PCB WORK ,go to gerber setup and do the process
3.Go to print option and SELECT PDF...
design various from circuit to circuit.....there are some standard rules for cb desigers
1.if it is a high current carrying trace, should set thicker as much as u can
2.an amplifer,speaker,mic etc needs traces with impedence matching ,means that the length should match
3.for couping capcitors...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
