Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
its supposed to show the main menu only which in this case is check signal cable coz im not connected it to Or even if its connected to Av cables or hdmi the same result i have
& it happens suddenly
thx
& its Samsung Plasma PS-42C7SG
i didnt understand anything of this!!
anyway my problem is ok when i changed the same code to PIC16F628 & put it in other Box far away from the contactors
but in general how to set the unused pins of the mcu ?
set it to inputs or outputs ?
& as i see you dont like pics (Toy oriented MCU) so what...
ok thx i've used WDT with assembly before i'll try to use it with mikroC i think i should use assembly to clear WDT right?
But how can i resume the same operation after reset ?
i'll try to put the board far from the 24AC contactors & im drawing a new board
- - - Updated - - -
i've decided to cut off the power its better i think in case the MCU has damaged
i've changed to 16F628 there is enough pins for my project
one qustion
is MCLRE enough to reset the MCU or should i use the emergency switch to cut the power off ?
thx for replys
hello Guys
i've made a simple controlller for 3 stages elevator
the main problem is tht when testing on proteus it works great & even on real board its ok but sometimes it make errors.
Errors like not responding to emergency push button(which its normally cloesed) OR
converting the input pins...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
