Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
:grin: Hi everyone, I'm kinda new to zener diode and wish to ask expert here for some guidance.
usually i only use zener as temporary overvoltage protection, but there are some occasion i use zener to bias a transistor for non critical power supply.
These are some of the things i dont...
Yes indeed, it is meant to be on all time when the polarity of Vin is correct, and off when Vin is reversed.
But if i operate the mosfet in this fashion, can it still take 0.75A?
Hi guys, i have one question in mind regarding P-mosfet,
I want to provide reverse polarity of input supply such as the simply schematic i attached.
However the datasheet usually specified Id current that is flowing from source to drain.
But my case is from drain to source instead. I did...
Re: IP3 measurement
sorry for the missing info,
im working on the LNA,gain at 18dB, i need to figure out the P1dB first.
the spectrum analyzer attenuation setting i set at very high value(50dB), i know that if my attenuation level is too low,the IM3 will appear to be very high,usually what i...
Re: IP3 measurement
:-Phi, i was searching for OIP3 information and i came across this thread.
I also have a similar question for the Pros here. I came across this situation when i work on LNA, all the while i'm thinking, as long as i very far below the P1dB point,then my OIP3 should be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
