Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi FvM,
Thanks a lot for your reply. The Balun unbalance port connect ceramic antenna, I don't find any phase requirement. So do you think I could ignore N, P pins connection.
Best Regards
Hello All,
I have a question about Balun balance ports, balance port1 and port2 are the same? which port could connect RF_N signal and which port culd connect RF_P signal, I couldn't get the information from Balun datasheet. thanks a lot.
Hi dharanklhar, Thanks a lot for your response. The antenna is Ceramic Antenna 2450AT18A100E, the Balun and antenna impedence is 50ohm, do you think we also need to redesign matching net?
BTW, there is no GND under Antenna, so do you think the GND will impact wire antenna performance? The wire I...
Hi all,
Currently, I got a problem of Blueteeth antenna short transfer distance issue, the spectrum analyzer shows it could get right frequency band (2.4-2.5G), I try to exchange different type of Balun, no improvement. However, when I use a wire instead of antenna, it improve large. who could...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
