Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
there is no burn mark s on pcb and the supply is ok as it was not in use for some months .
there is 20mhz crystal two PC817 opto isloators for panel control ok i will try to get the picture of the board sorry its not so clear
i Have a dead gym tread mill unit i suspect the ic ATMEGA48-20PU is faulty
or needs to be re programed supply is ok crystal 20MHZ is ok
i am new with this
there is one sticker sayimg Model number TRC5001(2B)-DOACO (B46V/42V)
on the unit .IC has a sticker 48-N15 DOACO-000886FDI-13KM if i...
PLEASE CAN SOMEONE MODIFY THIS FOR 10HZ to 60MHZ using BF199 and 10uh ,100nf at input for personal use
like EG : Electronics DIY - Electronic Schematics FM Transmitters TV Transmitters Stereo Transmitters
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.