Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
555 Toggle Circuit - Final
I do not know what you mean "buzzer for warning". I did find the culprits, though.
This goes in a tube amp.
First, I had to increase the reset delay timing cap to 10uF because it takes a long time for the system to stabilize. I monitored my tube voltages and...
Stable 555 Toggle Circuit
There were problems with a faulty pushbutton, timers of unkown quality and condition, and an unsoldered connection. After much testing, it appears the following always starts output low, and is stable.
It is probably overkill, but there are many unkowns in my...
Implementing the suggestion with a 7 sec. delay (verified), and retesting with PS storage caps discharged, here is the result:
If the system is left in ouput low state, on restart, the output goes high a few seconds after the 7 sec. delay.
If left in the output high state and restarted, the...
Hello folks.
The following circuit works perfectly, but sometimes the output will be high on power-up.
The storage cap on the 6VDC supply has a drain resistor that totally discharges the cap within 30 seconds. The problem may appear after hours of power-down/discharge.
A 10nF cap was added...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.