Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
first of all check hard drive status in BIOS if available there then you have to need to change your HDD. you have no option every thing will make you headeche :-)
i have made this project complete & working fine :-) but when inverter mode start showing 3 to 4 amp on zero load. i have test this circuit on transformer which was referred by imran brother Lahore.
Yes if you are working on RF signal or amplifying any singnal it can be use with low_pass filter but you need find out any high frequency FET which is suitable for your's circuit.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.