Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: inverting configuration of op-amp, output wave forms
then how will non inverting configuration works, even in this configuration the left side is positive and right side is negative, then why the signal is in phase.
please explain this configuration too.
Hello guys i facing a problem of inverting configuaration of opamp
in this configuration,the current start flowing through Ri, Rf to Vout, due to high input impedance no current flows to the input terminal of op-amp,
so my question was if there is no current flowing in the inverting...
hello,
im looking for the Half H bridge motor driver IC to drive a single brushed DC motor
specification of IC must contains.
Supply Voltage = 0 to 5.5V;
current PEAk output = 2.5A to 3A;
load type = Inductive;
Voltage Load = 6.5V to (35V - 50V);
mounting type = through hole;
interface = PWM...
if you have a current source of 500ma and a resistor of 1K in series with it then what would the current across the other end of the resistor.
please elaborate the answer.
Hello,
im designing a keypad i tried with 4*4,
but the total combination of the above condition is.
for 4*4 the total and max combination is 16.
and i want the total of 20 combinations so which technique i can use.
if you have only 8 wire
please suggest me something
can you please tell me what is the reason of connecting R and c across schottky diode
here is the attachment this is also present in smps circuits.
and why they are consider only this values
hello every one can anybody tell me what is the purpose of Vr1 and D5 in the circuit and why they are connected in this pattern and how it works in smps design for +12V, 5v with 1A output
and what is the purpose of TNY ic and what is the purpose of optocoupler to trigger the TNY ic
here is the...
im using a pic16f18323 to drive the motor instead of motor i have connected a leds there with a register value of 2.2K
it is 14 pin ic and i have used 6 i/p's as sensors and 2 for motor driver and 1 is open
here is the sensor ckt diagram
**broken link removed**
and the motors are driven by the...
hello sir im trying to do the ckt with AC signals for sensor and above is the sensor ckt diagram but im not understanding what is the purpose of in914 diode in the above ckt
because according to its datasheet the reverse vtg is 100v so why we need to use this diode
please tell me something...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
