Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
this webserver have a polish side also. So maybe somebody could help me.
I'd like to know what are the polish words for "Happy Birthday".
(and how is this spoken?)
thanxs,
Indi2Go
Re: opamp offset
If you want to do it with one OP you have to build a circuit like this:
**broken link removed**
on page 4 the circuit in the right upper corner:"Offset Voltage Adjustment for non inverting OP...."
With this circuit you can select the gain & offset seperatly.
Or you can use two...
Re: opamp offset
???, now you only measure the voltage with an offset....
You can look here (sorry this page is in german, i only know this one):
https://www.elektronik-kompendium.de/public/schaerer/opa1.htm
take a look at picture 5.3 (in german it is called BILD 5 and then the right...
Re: opamp offset
With Pin1 & 5 you can only compensate the offset of the opamp itself!
(the inputvoltage you need to get zero Volt at the output)
If you need an offset at the output you have to modify your external circuit.
You have to connect the 1k resistor to a negativ Voltage. (and not...
There are different methods..
one possible solution (quick & dirty, no range checking):
const h2c[]={0x30,0x31,0x32,0x33,0x34,0x35,0x36,0x37,0x38,0x39,0x41,0x42,0x43,0x44,0x45,0x46};
unsigned char hex_number;
char ascii_char;
main()
{
hex_number=0xA; //Number to convert...
I was interested in the XC-Family, but the Distributors (in Austria) only wants to sell a complet reel (1400 piece). But for the first shot we only need 300 per year...
So finally we changed the uP-family
Ind2Go
I recommend to keep the trace for JTAG very short!
I have trouble with 'long' lines and the JTAG-Interface(ISA-Card)
/IndiGo
PS.: I'm not allowed to give you the schematic of our board, but the
DSP-part is very close to the spectrum digital board....
Or you try to sold the BGA at home.
There is a german guy who did it with a electric iron and a hot air unit
The Webside is in german:
**broken link removed**
load error 291 eagle
If i work with V3.55 all things are right.
Now I have a look at V4.X and there happen some strange things.
When i make zooms or move some parts, some buttons disapear or
some layer are displayed wrong.
If I save the Board and open it again all thing are all right, but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.