Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Naresh,
No recruiter is gonna come to eda board for recruitment. So do make up your own job profile in job sites like naukri.com,timesjobs.com,monster.com,shine.com etc & search for the jobs which match to your profile. Also do search in the net for the companies of your domain & sent your...
Dear friends,
I have completed B.Tech in ECE & i have done Post Graduate diploma in Embedded Design Engineering which was for a duration of 8 months. I have a total working experience of 1.5 years & i am passionate in programming basically in C & assembly languages. For the last 6 months i have...
That is a good idea. Is their any way to split up the other phase to three so to compensate the varying phase or like that?
Thanking you,
Regards,
Jerin Johns.
Thanks for your reply. But i am not satisfied by the post. :-(
Let me explain my requirement once more. We have developed a product named as irrigation controller which is meant for farmers having irrigation facility in their fields.This device is connected to the starter of the motor used to...
Thanks for your reply. Could you please elaborate the working of VFD? Also is solution available in the controller level to solve this? If we could do this by using controller circuits it would be nice.
Thanking you,
Regards,
Jerin Johns.
Let me ask you a question dude. Where have you provided the delay in the for which the timer 0 should run & get reset? How much time are you expecting the timer0 to run? Please do explain it.
Regards,
Jerin Johns.
Thank you for your posts guys.
Actually my intention is not to maintain the supply voltages of the three phases. It is that can we distribute the 2 phase power into three so that we can operate the device in 3 phase power if one of the phase is too low.... Please give me an idea over solving...
Hi friends.
Actually i have come across a problem while working on a product of ours. The problem is in the power supply section. We are using three phase power supply basically for our product. The question is that in three phase supply system, if the voltage in one of the any three phases...
Thanx dinesh. You are almost there. Let me try what you have just posted above. Thank you for your reply buddy. I'll post the resulting code in the forum.
Thanking you,
Regards.
Jerin.
Thanx for your reply buddy. I know the things what you said above. My question is how can we implement this process with 2 different channels of ADC?
Thanking you,
Regards,
Jerin.
Hi all.
I'm confused how to configure ADC for my application. I need two ADCs for my project. At channel-1 i need to measure the variation of a float sensor & at second channel i need to measure the variation of a thermal sensor. Can anyone suggest me a method to tackle this situation? I'm...
No. Hitech-C is instaled in a different way rather than that of MPLAB IDE. The software should be bought & i think there are rare chances to find it in net. What do you mean by "going further"?
Regards,
Jerin.
Dear cadvis,
You may be having in correct working because of the absence of the delay5 routine. Just check the code once more after including it in the code.
Regards,
Jerin. ;-)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
