Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi all
i want to make an amplifier on germanium transistors,
but i have some questions about the circuit.
if i try to simulate the amplifier in a microcap, the circuit does not work,
i changed it as if it was made on silicon - it worked.
but i need EXACTLY the germanium version ...
Re: what is the difference between SDHC & SDXC
i know that
i asked about initialization of sdxc memory card.
futhermore SDXC can be partitioned and formatted in FAT32
does anyone work with SDXC memory card?
in 2013 i made a seismostation which writes data on SDHC card with 32 Gb capacity
now i need to write more then 32 Gb data
and i try to use SDXC for that
i read specs and i don't find difference in initialization both types of cards
may be i haven't paid...
i have u-controller with two ethernets on the board (with mac and phy) and i want to assign address by a dhcp (or set its statically).
address was assigned succesful, udp server launched on every eth but only 1 eth works right.
my prog uses freertos and lwip. every eth separately works fine...
Hi.
i use lsm303 for accelerations measuring. i want to get data rate greater then 1Hz but DRDY output switched with 1Hz only on all settings. i set LOWPOWER mode and i set NORMAL mode in registers but nothing come out.
does anyone help me?
- - - Updated - - -
i've solved the problem
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.