Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i managed to draw the shape i wanted using draw=>line ... now the problem is defining the connection point between the PCB and the antenna as feeding point (excuse the lack of aproperiate HFSS lingo being a beginner and all :) ) .. any suggestions ?
Greetings all,
as you will conclude from my question i am a complete newbie in HFSS.
i have this design problem, a pcb with a monopole wire sticking out and it is bent to be parallel to the surface in a ' Π ' shape. i have no clue how to go about doing that, so if anyone can help it would be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.