Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
To prevent this dead zone , u must be in a continuous mode.
This simply can be achieved by increasing the filter inductance or increasing the switching frequency or both.
Hi, ark5230
I want to tell u that the problem is not in the device addressing (The device addressing is the same)
But the problem is in that
in the 24c64 ........ the address of the location to be read or written is two bytes. But in the 24c04 ........ that address is only one byte.
u can use...
Re: eagle drill chart
Hi, Guys
i want to put some components in the bottom layer in my PCB (i use eagle software).
Can i make that just by mirror the component ? or there is another step beside that?
Are there a difference between placing the (DIP components or Resistors etc.) and the (SMD...
1st i would tell u that u can easily interface the ATmega32 with the 24C04 through the I2C bus.
About the address
the address pins in each ic is set by u to make the total address of the device (the EEPROM) and then u must send that address to the device and the device will acknowledge
these...
yes, u can put a scope probe across this sense resistor.
The important note is that when u use the second channel of your scope, u must connect the reference of the probe (the crocodile) to the crocodile of the 1st probe or u can left it unconnected (as there are internally connected together)...
u can easily program it through the isp programmer (usb asp), just connect the pins of (MOSI, MISO, SCK, RESET, VCC, GND) of the Attiny85 to the similar pins in the programmer
u should make a project and compile it and build it then the hex file will be generated.
the default setup is ok. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.